The method of limits is used to compare the pitch of a complex to that of a pure tone.

This protocol runs a descending limits test followed by an ascending limits test.

Instructions

Enter the parameters in the fields below, then click begin.


Parameters
Ear      Results
dB SPL - Tone Level
Number of Components
Hz - Complex Center Frequency      Hz - Complex Frequency Spacing
Hz - Initial Matching Frequency      Hz - Matching Delta
ms - ISI
dB SPL - Noise Level
ms Tone Initial Pause
ms - Tone Rise Time
ms - Tone On Time
ms - Tone Fall Time
ms - Noise Initial Pause
ms - Noise Rise Time
ms - Noise On Time
ms - Noise Fall Time
Hz - Noise High-Pass Frequency
Hz - Noise Low-Pass Frequency
dB SPL - Calibration
Hz - Sample Rate