Tuesday plans:
 - Car trip to Brookline to pick up remaining tools, seats, fasteners, etc.
   (Steve, Scott?)
 - Design, measurement, and drawings for floatation system
 - Get hooked up with 240V again
 - Reattach front end and block it up with correct alignment.
 - Weld front diagonal runners

Meet at the new SOUTHIE SITE - 8 PM

Accomplished Tuesday:
 - Delivered 80% of materials and tools from Brookline to Southie
 - Operation Interphase II executed successfully
 - Grinding to prep patch areas: firewall, floor, crusty front wings
 - Welding of rear body seam (75% complete)

Notes:
 - Attachment of front body section and pontoon runners put off until
   firewall patching is complete and Vinnie-cut(tm) radiator section
   is reattached.
 - Lesson learned: long body lap joints need to be stitch-welded.  Heat
   stress from one long pass causes unwelded areas ahead of gun to buckle.
 - Needed from Brookline: 100' extension cord, box of precut patches,
   remaining seat, and whatever else is left.
 - Needed from Cruftlabs or elsewhere: fans (box or otherwise),
   raw sheet steel, oxy-acetylene welding rig, brazing rods
 - Check on supply of welding wire tonight.
 - I'll try to run remainder of propulsion calculations today.

Wednesday plans:
 - Manned Mission to Mar's (for science!)
 - Reattach radiator stiffening section
 - Install firewall patches (maybe try brazing?)
 - Install, block up body front
 - Attach front diagonal runners
 - Finish welding transverse body lap joints

WEDNESDAY NIGHT - SOUTHIE - 8 PM
We can do another group cycling trip if folks are interested.
It's a pleasant ride.