Berkeley DB Reference Guide:
Locking Subsystem

PrevRefNext

Configuring locking: sizing the system

The lock system is sized using the following three functions:

DB_ENV->set_lk_max_locks
DB_ENV->set_lk_max_lockers
DB_ENV->set_lk_max_objects

The DB_ENV->set_lk_max_locks, DB_ENV->set_lk_max_lockers, and DB_ENV->set_lk_max_objects methods specify the maximum number of locks, lockers, and locked objects supported by the lock subsystem, respectively. The maximum number of locks is the number of locks that can be simultaneously requested in the system. The maximum number of lockers is the number of lockers that can simultaneously request locks in the system. The maximum number of lock objects is the number of objects that can simultaneously be locked in the system. Selecting appropriate values requires an understanding of your application and its databases. If the values are too small, requests for locks in an application will fail. If the values are too large, the locking subsystem will consume more resources than is necessary. It is better to err in the direction of allocating too many locks, lockers, and objects because increasing the number of locks does not require large amounts of additional resources.

The recommended algorithm for selecting the maximum number of locks, lockers, and lock objects is to run the application under stressful conditions and then review the lock system's statistics to determine the maximum number of locks, lockers, and lock objects that were used. Then, double these values for safety. However, in some large applications, finer granularity of control is necessary in order to minimize the size of the Lock subsystem.

The maximum number of lockers can be estimated as follows:

The maximum number of lock objects needed can be estimated as follows:

For all access methods, you should then add an additional lock object per database for the database's metadata page.

The maximum number of locks required by an application cannot be easily estimated. It is possible to calculate a maximum number of locks by multiplying the maximum number of lockers, times the maximum number of lock objects, times two (two for the two possible lock modes for each object, read and write). However, this is a pessimal value, and real applications are unlikely to actually need that many locks. Reviewing the Lock subsystem statistics is the best way to determine this value.

PrevRefNext

Copyright Sleepycat Software