The OPTIMIZE command joins wire segments which lie in one straight line. The individual segments must be on the same layer and have the same width. This command is useful to reduce the number of objects in a drawing and to facilitate moving a complete track instead of individual segments.
If signal names are given, or a signal is selected, the command affects only the respective signals.
This wire optimization takes place automatically after MOVE, SPLIT, or ROUTE commands unless it is disabled with the command:
SET OPTIMIZING OFF;or you have clicked the same spot twice with the SPLIT command.
The OPTIMIZE command works in any case, no matter if Optimizing is enabled or disabled.
|Index||Copyright © 2005 CadSoft Computer GmbH|