The PINSWAP command is used to swap pins within the same symbol which have been allocated the same swaplevel (> 0). Swaplevel, see PIN command. If a board is tied to a schematic via Back Annotation two pads can only be swapped if the related pins are swappable.
On a board without a schematic this command permits two pads in the same package to be swapped. The Swaplevel is not checked in this case.
Wires attached to the swapped pins are moved with the pins so that short circuits may appear. Please perform the DRC and correct possible errors.
| Index | Copyright © 2005 CadSoft Computer GmbH |